Thermoelectric microstructures of Bi2Te3/Sb2Te3 for a self-calibrated micropyro...

• Autor(es): Gonçalves, L. M. ; Couto, Carlos ; Correia, J. H. ; Alpuim, P. ; Rowe, D. M.
• Data: 2006
• Identificador Persistente: http://hdl.handle.net/1822/5525
• Origem: RepositóriUM - Universidade do Minho
• Assunto(s): Thermoelectric; Thin-film; Pyrometer; Peltier; micro-cooler; Bi2Te3
• Tipo de Documento: Artigo
• Idioma: Inglês

Descrição

The fabrication of thermopiles suitable for thermoelectric cooling and energy generation using Bi2Te3 and Sb2Te3 as n- and p-type layers, respectively, is reported. The thin-film thermoelectric material deposition process, thin-film electronic characterization and device simulation is addressed. The thermoelectric thin-films were deposited by co-evaporation of Bi and Te, for the n-type element and Sb and Te, for the p-type element. Seebeck coefficients of −190 and +150 uVK−1 and electrical resistivities of 8 and 15 uOhm.m were measured at room temperature on Bi2Te3 and Sb2Te3 films, respectively. These values are better than those reported in the literature for films deposited by co-sputtering or electrochemical deposition and are close to those reported for films deposited by metal-organic chemical vapour deposition and flash evaporation. A small device with a cold area of 4mm×4mm and four pairs of p–n junctions was fabricated on a Kapton® substrate, showing the possibility of application in Peltier cooling, infrared detection and energy generation. Small devices fabricated on a polyimide (Kapton®) substrate and micro-devices fabricated on a silicon nitride substrate were simulated using finite element analysis. The simulations show the possibility of achieving near 20K cooling over 1mm2 areas.