Optimization of deposition parameters for thin silicon films on flexible substr...

• Author(s): Alpuim, P. ; Ribeiro, M. ; Filonovich, Sergey
• Date: 2006
• Persistent ID: http://hdl.handle.net/1822/5554
• Origin: RepositóriUM - Universidade do Minho
• Subject(s): Nanocrystalline silicon; Hot-wire CVD; Flexible electronics; Thin-film solar cell
• Document Type: Article
• Language: English

Description

This paper studies the deposition of thin silicon films from silane on plastic substrates in a recently build hot-wire chemical vapor deposition reactor. Hydrogen dilution of silane was used to induce amorphous-to-nanocrystalline phase transition. Thin-film deposition rate, r(d), is roughly proportional to silane concentration during deposition but the proportionality factor depends on filament temperature, T-fil. At T-fil similar to 2500 degrees C (1900 degrees C), r(d) increases from 2.1 angstrom/s (1.2 angstrom/s) at 97% H-2 dilution to 14.5 angstrom/s (10.7 angstrom/s) for films deposited from pure silane. At T-fil similar to 2500 degrees C, films deposited under 80% H-2 dilution were amorphous, under 90% H-2 dilution the crystalline fraction was X-C = 49.4% and under 95% H-2 dilution, X-C = 52.8%. At T-fil similar to 1900 degrees C, samples were amorphous up to similar to 95% H-2 dilution where a crystalline fraction of 22.3% was measured. Films with amorphous structure have sigma(d) similar to 10(-10)-10(-9) Omega(-1.)cm(-1) while those with a measured crystalline fraction have sigma(d)similar to 10(-7)-10(-5) Omega(-1)cm(-1), depending on the amount of crystalline fraction and grain size. Films with lower sigma(d) have optical band gap in the range similar to 1.85-1.9 eV, typical of hydrogenated amorphous silicon, while those with higher sigma(d) have larger optical band gap (similar to 2 eV), typical of hydrogenated nanocrystalline silicon. Adhesion of the films to the plastic substrate was good, as they survived bending to small radius of curvature (< 1 mm) without peeling. Structural, optical and transport properties were similar on films deposited both on PEN and on glass under the same deposition conditions.